The widespread use of routers is based on their ability to perform
an extensive range of smooth finishing and decorative cuts.

Your safety in operating a router starts with an understanding that
it operates at a very high speed – in the 20,000 RPM range. From
15 to 25 times faster than a drill.

Always wear safety goggles or safety glasses with side shields
complying with current national standard, and a full face shield
when needed. Use a dust mask in dusty work conditions. Wear
hearing protection during extended periods of operation.

Do not wear gloves, loose clothing, jewelry or any dangling objects
that may catch in rotating parts or accessories. Tie back long hair.

Install router bits securely, and according to the owner/operators
manual.

Always use the wrenches provided with the tool.

Keep a firm grip with both hands on your router at all times —
failure to do so could result in loss of control, leading to possible
serious injury.

Read your operators manual carefully regarding laminate trimmers
and other small routers that are used one-handed.

Always face the cutter blade opening away from your body.

When starting a router equipped with carbide tipped bits, the router
should be started beneath a work bench to protect operator from a
possible flying cutter should the carbide be cracked.

Hold only those gripping surfaces of the router designated by the
manufacturer. Check your owner/operators manual.

If your router is equipped with a chip shield, keep it properly
installed.

Keep your hands away from bits or cutter areas when the router
is plugged in.

Do not reach underneath the work while bits are rotating. Never
attempt to remove debris while the router is operating.

Always disconnect the plug from the electrical outlet before
changing bits or making any adjustments. If you are changing a
bit immediately after use, be careful not to touch the bit or the
collet with your hands or fingers. They could get burned because
of heat build-up from cutting.

Your desired cutting depth adjustments should be made only
according to the tool manufacturer's recommended procedures for
these adjustments. Tighten adjustment locks. Make certain that the
cutter shaft is engaged in the collet at least 1/2 in. Check your
owner/operators manual carefully.

Be certain to secure clamping devices on the workpiece you are
using before operating your router.

The switch should be in the ''off '' position before plugging into the
power outlet.

For greater control, always allow the motor to reach full speed
before feeding the router into the work.

Never force a router.

When removing a router from your workpiece, always be very
careful not to turn the base and bit toward you.

Unplug and store your router immediately after use.

A router can inflict serious injury in the hands of children or
the untrained.